Need help?Do you have a question about the GigRig G2 and is the answer not in the manual?
General| Loops | 10 |
|---|---|
| MIDI In/Out | Yes |
| USB | Yes |
| Power Supply | 9V DC |
| Switching System | True Bypass |
| Type | Programmable loop switcher |
Details the 14 footswitches available on the G2 unit for preset selection.
Enables layering sounds without clearing previous selections, offering stompbox-like operation.
Activates and adjusts the Post Gain feature for volume boosts after effects.
How to program and activate specific effects loops for each preset.
Activates and adjusts the Pre Gain feature for volume boosts before effects.
Controls signal level before effects or provides a buffered output.
Controls signal level after effects, with adjustable positioning.
How to use remote switches to control external gear like amps.
Detailed guide to using independent outputs for stereo/dual amp setups.
Dedicated loop for volume pedals or amp FX loops, connected to Post Gain.
Ability to reposition the volume insert point using special functions.
Transmitting MIDI patch change messages to external devices.
Restores the G2 to its original factory settings, erasing all user data.
Determines the location of the volume pedal insert and mixer input.
Configures MIDI channel sends for each footswitch, up to three channels.
Step-by-step guide to resetting the G2 to its original factory settings.
Instructions for integrating the G2 with an amplifier's effects loop.
Recommendations for arranging effects pedals in the signal chain.
Technical description of the true bypass signal path for Output 1.
Technical description of the buffered and isolated signal path for Output 2.
To Next Page
