© TheGigRig Ltd 2013
5
3. BUTTONS AND CONNECTIONS
1. Footswitch – There are 14 footswitches on the G2.
2. Phase Out 2 – This button reverses the phase on OUT2. If you use
two amps then you can ensure that both amps are always in phase.
This is a global command and effects ALL footswitches, however, it
is possible to program a different phase per preset. This button is
also used to enter the special functions. See the Advanced Functions section.
3. Bank Up Engage – This is how you access the banks. Press the BANK UP ENGAGE
button and you’ll see lights 1~8 flash. Simply select the bank you want, and then press
the preset you want to engage. G2 has 120 presets.
4. OUTPUTS 1&2 – Choose any combination of outputs 1&2 per preset.
5. STOMP BOX MODE – You can set up your presets in 2 different states. The first is
standard preset mode where you press the footswitch and it clears the previous
selection, and the second is STOMP BOX MODE, which lets you add/layer sounds
together WITHOUT clearing the previous sound.
6. REMOTE SWITCHES – There are 4 isolated latching remote switches via 2 TRS
connections.
7. POST GAIN ON – This button will turn on the POST GAIN feature for this pre-set. (Press
and hold for 3 seconds UNITY GAIN. This circuit can be moved after any loop. See
special functions footswitch number 5.
8. POST GAIN VOLUME SELECT – These two UP and DOWN buttons allow you to
precisely set the level of POST gain. Hold the button down to increase rapidly, or press
individually for fine-tuning.
To Next Page
Loading...
Need help?
General
