03_10
03_11
Sparkplugdismantlement (03_10, 03_11)
Proceed as follows:
1. Remove the right side cover unscrewing the 3 «A» screws;
2. Disconnect the spark plug HV wire hood «B» ;
3. Unscrew the spark plug using the wrench supplied. ;
4. When refitting, place the spark plug in the hole at the due inclination and tighten it
by hand until it is finger tight;
5. Only use the wrench to lock it in place;
6. Push hood «B» fully over the spark plug.
WARNING
THE USE OF SPARK PLUGS OTHER THAN THOSE RECOMMENDED OR A
SHIELDLESS SPARK PLUG CAP COULD CAUSE DISTURBANCES TO THE SYS-
TEM.
WARNING
THE SPARK PLUG MUST BE REMOVED WHEN THE ENGINE IS COLD. THE
SPARK PLUG MUST BE REPLACED EVERY 20,000 KM. USE OF ELECTRONIC
CONTROL UNITS OR ELECTRONIC IGNITIONS DIFFERING FROM THOSE REC-
OMMENDED CAN SERIOUSLY DAMAGE THE ENGINE.
Characteristic
Spark plug
CHAMPION RG 4 PHP
Electric characteristic
Electrode gap
0.7 - 0.8 mm
53
To Next Page
