WARNING
THE WHEELS FITTED WITH TYRES SHOULD ALWAYS BE BALANCED. RIDING
THE VEHICLE WITH VERY LOW TYRE PRESSURE OR WITH INCORRECTLY
BALANCED TYRES CAN LEAD TO DANGEROUS STEERING VIBRATIONS.
03_46
delveicolo (03_46)
The following operations are recommended:
1. Clean the scooter thoroughly and then cover it with a canvas;
2. With the engine off and the piston at the bottom dead centre position, remove the
spark plug, and pour 1 ÷ 2 cm³ of the recommended oil through its hole. Operate the
starter button 1-2 times for roughly 1 second to turn the engine over slowly, then insert
the spark plug again;
3. Ensure that the fuel tank is at least half full (so that the fuel pump is fully
covered); spread antirust grease on the uncoated metal parts; keep the wheels lifted
above the ground by resting the chassis on two wooden wedges;
4. As regards the battery, follow the instructions in the «Battery» section.
Recommended products
eni i-Ride PG 5W-40
Synthetic based lubricant for high-performance four-stroke engines.
JASO MA, MA2 - API SL - ACEA A3
Cleaningthevehicle
In order to soften the dirt and mud deposited on the painted surfaces, use a low pres-
sure jet of water. Once softened, mud and dirt should be removed with a soft sponge
76
To Next Page
Loading...
