Gilera NEXUS 300 i.e. - Spark Plug Dismantlement

TYRE INFLATION PRESSURE
Front tyre pressure (with
passenger)
2.3 bar (2.3)
Rear tyre pressure (with
passenger)
2.3 bar (2.5)
03_07
03_08
Spark plug dismantlement (03_07, 03_08, 03_09)
Proceed as follows:
1. Lift the rubber mat;
2. Remove the right side cover by unscrewing the three screws «A»;
3. Disconnect spark plug HV wire cap «B» ;
4. Unscrew the spark plug using the wrench supplied;
5. Upon refitting, place the spark plug in the hole at the due inclination and finger
tighten it;
6. Only use the wrench to lock it in place;
7. Place cap «B» fully over the spark plug.
WARNING
THE USE OF SPARK PLUGS OTHER THAN THOSE RECOMMENDED OR A
SHIELDLESS SPARK PLUG CAP COULD CAUSE DISTURBANCES TO THE SYS-
TEM.
CAUTION
SPARK PLUG MUST BE REMOVED WHEN THE ENGINE IS COLD. REPLACE
SPARK PLUGS AS INDICATED IN THE SCHEDULED MAINTENANCE TABLE.
50
3 Maintenance