03_29
N.B.
THE ABOVE PROCEDURE COMPLIES WITH THE EUROPEAN STANDARDS RE-
GARDING MAXIMUM AND MINIMUM HEIGHT OF LIGHT BEAMS. REFER TO THE
STATUTORY REGULATIONS IN FORCE IN EVERY COUNTRY WHERE THE ve-
hicle IS USED.
Turn the screw «A» clockwise to lower the light beam, turn the set screw «A» anti-
clockwise to raise the light beam.
03_30
Front direction indicators (03_30, 03_31)
To replace the burnt out bulb remove the 3 screws «A » shown in the figure, and then
take the rubber holder off its socket;
64
To Next Page