WindSonic Doc No 1405 PS 0019 Issue 28 November 2019
29
Status
This indicates either
Correct operation Code 00 and A (NMEA).
or Error codes See Section 11.5 for explanation of codes.
Checksum
This enables the host system to check that the data has been correctly received. This is the
EXCLUSIVE – OR of the bytes between (and not including) the <STX> and <ETX>
characters.
Output rate (not displayed)
The WindSonic samples continuously and delivers wind information at ¼, ½, 1 (default
setting), 2, or 4 outputs / second.
To Next Page
Loading...