Gill WindSonic User Manual

WindSonic Doc No 1405 PS 0019 Issue 28 November 2019
52
Fx - Data and parity options
Item
Options
Command
Data and parity options
8 bits, no parity
8 bits, even parity
8 bits, odd parity
F1
F2
F3
Gx - (To be allocated for future developments)
Item
Options
Command
To be allocated
Not Applicable
Gx
Hx - Power-up Message
Item
Options
Command
Power –up message
ON
OFF
H1
H2
If the power up message is On, then a message similar to that below is output, whenever
the unit goes into Measurement mode (i.e. when power is first applied to the unit, or unit
returns to Measurement mode from Configuration mode).
WINDSONIC (Gill Instruments Ltd)
2368-110-01
RS485/RS422 (CFG)
CHECKSUM ROM:E15C E15C *PASS*
CHECKSUM FAC:0A42 0A42 *PASS*
CHECKSUM ENG:12BE 12BE *PASS*
CHECKSUM CAL:C980 C980 *PASS*
If any of these checksums fail, the word PASS will be replaced by FAIL and the unit will
use its default settings. If the checksum repeatedly fails after power on – contact your
supplier.
NOTE: The exact message above may vary.

Gill WindSonic Specifications

General

Brand	Gill
Model	WindSonic
Category	Measuring Instruments
Language	English