WindSonic Doc No 1405 PS 0019 Issue 28 November 2019
42
To change a setting i.e. change from M2 (Polar) to M1 (UV), select M1 from the Wizard
drop down list then click on Next.
The following screen will show settings that will be changed.
Then click on Next.
Wind will report Setting Up Anemometer and then re-start the anemometer scrolling data in
UV mode.
Note: - It is also possible to change settings in Wind using the Configuration Mode
operation and using Commands listed in Para’s 10.4 to 10.7.1.
To Next Page
Loading...
Need help?
General