Unplug from outlet when machine is unattended, not in use and before cleaning. Allow cooling before putting on or taking off
parts.
Never allow any contact of machine’s internal and external parts with any kind of liquids (i.e. cleaning products etc.).
Unplug from water mains when unattended, not in use and before cleaning.
Do not operate any appliance with a damaged cord, plugs, or after the appliance malfunctions or has been damaged in any
manner. Do always contact the authorised technical service.
The use of accessory attachments not recommended by the appliance manufacturer may cause injuries.
Do not use outdoors.
Do not let cord hang over edge of table or counter, or touch hot surfaces.
Do not place on or near a hot gas or electric burner or in a heated oven.
Extreme caution must be used when moving an appliance containing hot oil or other hot liquids.
To disconnect the plug from the wall outlet, turn any control to “off”, then remove plug.
Do not use appliance for other than intended use, which is preparation of coffee, dispensing of hot water and steam.
The information contained in this manual relating to installation and operation is not a substitute for safety instructions and
technical data affixed to the machine and/or its packaging.
The manual provides information that is current at the time of publication. The information is subject to amendment or
alteration without notice.
Installation and maintenance should only be carried out by technicians and service providers authorised by the manufacturer.
The manufacturer accepts no liability for injury and damage to person, persons or property caused by incorrect installation,
misuse, and operator negligence, neglect of the machine or any other circumstances beyond its control.
Maximum water inlet pressure is 5 bars (0,5 MPa). Please install a pressing reducing valve if water pressure from the mains is
higher.
The machine should not be operated with temperatures under 8°C (46°F) and over 44 °C (110 °F).
The instruction for installation of class I appliances of the professional type which are intended to be permanently connected to
fixed wiring, the leakage current of which may exceed 10mA, states that the installation of a residual current device (RCD)
having a rated residual operating current not exceeding 30mA is advisable.
Means for disconnection with contact separation in all active (phase) conductors. The means for disconnection must be
incorporated in the fixed wiring according to the wiring rules
Height of the support on which the machine is to be installed: this height has to be at least of 105 cm.
The machine must be used exclusively with clean fresh drinking water.
Save these instructions.
To Next Page
Loading...