Gime HT 21 - Portion Programming; Programming Coffee Portions; Programming Hot Water Portions

Manuale d’uso per machine da caffè GIME HT21-2013. Con riserva di modifiche.
User Manual for GIME HT21-2013 Espresso Coffee Machines. Specifications subject to change without notice.
28
13. Idle – off
Idle off means that the machine is electrically feeded just to allow programming the software. In “idle off” the machine cannot
be used to dispense coffee or hot water.
How to set the Idle off mode:
Push K5GR1 and sequently K3GR1 until appear on the display the OFF indication, to go back to normal machine operation
(Idle on), you have to repeat the key sequence K5GR1 and K3GR1
14. Portion programming (setting)
Please note that prior to program the machine has to be ready to operate.
We strongly recommend programming coffee portions “under working conditions”. This is to say using the right filter basket,
filter holder and amount of ground coffee.
Programming of Automatic Coffee Product Keys (K1, K2, K3, K4)
Please note that all automatic coffee product keys are set on the keyboard of the left hand group (seen always from
operator side of the machine.
After having programmed the automatic coffee portion keys on the left hand group, also the automatic coffee product
keys of the other groups are set with the same portions. You need to program all or some of the other group touchpad
coffee product keys only if you wish to set different portions from the left hand group’s portions keys.
Programming of Automatic Hot Water Product Key
Ho
t water keys have to be programmed individually for each touchpad.
1. Keep button K5 of left side group pressed until all leds on top of the product keys light on.
2. Release button K5 and press the tea key to be programmed. The product dispensing will start.
3. Once the desired quantity of hot water has been dispensed, press this product key again to terminate.
5. When you’re done with portion setting of the product keys of the touchpad you’re working on, please press its key K5 again
to confirm the portion settings and to exit programming.
Note: as hot water portion control is time controlled, the effective quantity dispensed depends from the boiler pressure, which
might vary under different working conditions. Therefore the portion might be reprogrammed to guarantee accurate portions.