Giorik Steambox Evolution SETE102 - Spare Parts Management; 6 Alarms Description

54
5.5 SPARE PARTS MANAGEMENT
The parts should be replaced exclusively by an authorized service
centre�
To identify the codes of spare parts, contact a service representative�
Once the parts required have been identied, the after-sales service
will send a written order to the manufacturer, specifying clearly the
model of the device, its serial number, the voltage and frequency
of power supply, and also the code and a description of the parts
concerned.
Only original spare parts must be used for protection of the health
of the user and consumer.
6. ALARMS DESCRIPTION
If an alarm is triggered, on temperature and time display is shown the
name of the alarm triggered�
The alarms managed are the following
Name Description Actions SOLUTION
E01 -
Chamber
probe
Chamber probe failure Cooking cycle
block; automatic
reset�
Replace the chamber probe�
E17 -
Pin probe
Pin probe failure Manual reset� Replace the pin probe�
E12 - GAS Gas burner block Cooking cycle
block, manual
reset�
Press manual restore� (encoder
button); if the problem persists,
contact the support centre�
E13 -
GAS 2
Second gas burner block Cooking cycle
block, manual
reset�
Press manual restore� (encoder
button); if the problem persists,
contact the support centre�
E05 -
Safety
motor
Motor Alarm Cooking cycle
block; automatic
reset�
If the problem persists, contact
the support centre�
E11 -
Safety
motor
Motor Alarm Cooking cycle
block; automatic
reset�
If the problem persists, contact
the support centre�
E03 -
Peripheral
Motor Inverter Alarm Cooking cycle
block; automatic
reset�
If the problem persists, contact
the support centre�