INSTALLATION INSTRUCTIONS
FOR PERSONAL SAFETY AND QUALITY OF INSTALLATION, A MINIMUM OF
TWO INSTALLERS IS RECOMMENDED FOR THIS PRODUCT.
Before beginning to install the awning please verify the following;
• The vehicle is parked and leveled on suitable hard standing.
• Suitable precautions have been taken to protect the vehicle from accidental
damage.
• The area of the vehicle where the awning is to be installed has been prepared.
• Sufficient manpower, a minimum of 2 persons is required.
• Suitable protective clothing is worn by the persons doing the installation.
• Suitable and serviceable lifting and holding equipment should be used to avoid
personal injury.
• When mounting fixtures to the vehicle be aware that the soft materials that the
skin of the vehicle is made from can be torn out or “Stripped” by the over
tightening of fasteners.
DO NOT OVER TIGHTEN FIXING BOLTS AND SCREWS.
• Make every effort to ensure that fasteners are mounted to the structural
framework of the vehicle not just the skin.
• Any holes made in the skin of the vehicle must be sealed with silicone sealant,
putty tape or similar product.
ALL ELECTRICAL WORK MUST CONFORM TO APPLICABLE
ELECTRICAL CODES AND STANDARDS.
• Turn off power before beginning any electrical work.
• Please consult your RV’s wiring diagram to locate any wiring
prior to any drilling or any installation procedures.
• Ensure that placement of controls, cables, and wires are not
in any way obstructed. This can damage the components and
obstruct electrical current.
• Use only certified components.
To Next Page
Loading...
