A. UNPACKING
Before starting any of the installation procedures:
1. Unpack the awning and inspect the product for any possible damage that
may have occurred during shipping.
2. Ensure that the length and motor placement of your awning are correct.
3. When you have determined that the product is to your satisfaction, remove
the mounting brackets and place the awning in a safe location while
preparing the RV.
a. To remove the brackets locate the slide lock that retains the bracket to
the housing. (Figure 1)
b. Using a 13mm or ½” wrench, loosen all set screws on the slide locks.
c. Once the set screws have been loosened the slide locks should slide
freely, clear the slide lock away from the bracket.
4. If you have discovered any damage or missing parts please contact your
supplier.
Figure 1
To Next Page
Loading...
