GL-INET Spitz - Page 120

Page 115 | 168
Model
Tor firmware path
Newest
Version
Note
GL.iNet6416
https://dl.gl-inet.com/firmware/6416/tor/
1.3
AR150
https://dl.gl-inet.com/firmware/ar150/tor/
2.264
AR300M
https://dl.gl-
inet.com/firmware/ar300m/nand/tor/
2.264
.rar is for web upgrade .img is
for uboot upgrade
AR300M-
Nor
https://dl.gl-
inet.com/firmware/ar300m/tor/
2.264
MT300N
https://dl.gl-
inet.com/firmware/mt300n/tor/
2.264
MT300A
https://dl.gl-
inet.com/firmware/mt300a/tor/
2.264
GL-MiFi
https://dl.gl-inet.com/firmware/ar150/tor/
1.3
MiFi don't have a Tor
firmware itself. Use AR150
1.3 instead
GL-AR300
https://dl.gl-inet.com/firmware/ar300/tor/
1.3
GL-MT750
Not supported yet
AR750
Not supported yet
Using the firmware UI
After you flash the firmware to your device, when it reboots you need to set up
the device at http://192.168.8.1.
If you need to connect via WiFi, the default wifi password is goodlife.
!!! NOTE
You need to move the hardware switch to the right side if you want to
access the UI. Otherwise you are connecting to the Tor network and will not be
able to access the UI. This is for security reasons.
First time setup
The first time you acess the setting UI, you will be asked to setup a new
password immediatelly. Just choose a password and your TimeZone and submit.
The device will NOT reboot in firmware 1.4.
NOTE: This doesn't change your WiFi password. Change it later.