To Next PageTo Next PageWhat to do if the sensor light is on but there is no water from my Glacier bay MARCIE RF412034?
If the sensor light on your Glacier Bay Plumbing Product is always on, but no water comes out when activated, the power may be low. Try replacing the batteries.
Why does the water stop running during use with my Glacier bay MARCIE RF412034?
If the water stops running during use with your Glacier Bay Plumbing Product, it might be due to several reasons. First, the sensor may have been activated by an object or your hand; wave your hand again in front of the sensor to turn the water on. Second, the water supply pipe may have temporarily stopped providing water; wait for the water line to come back on. Finally, continuous water running may have exceeded 180 seconds; reactivate the sensor to turn the water on.
Why is the sensor light flashing on my Glacier Bay Plumbing Product?
If the sensor light flashes continuously when waving in front of the sensor on your Glacier Bay Plumbing Product, it indicates low power. Replace the batteries to resolve this issue.
How to fix water that won't turn off on my Glacier bay MARCIE RF412034 Plumbing Product?
If the water cannot be turned off when sensing with your Glacier Bay Plumbing Product, it could be due to a few reasons. First, the power supply might be low; replace the batteries. Second, the water pressure may be too low; pressurize the water supply pipeline. Third, the pull-down hose might not be retracted; check under the sink for any obstructions causing the pull-down hose to get stuck, and rearrange as needed for the hose to move freely.
General| Brand | Glacier bay |
|---|---|
| Model | MARCIE RF412034 |
| Category | Plumbing Product |
| Language | English |
Details the limited lifetime warranty for Glacier Bay products, covering defects in materials or workmanship.
Ensures all parts are present and undamaged before commencing installation, contacting customer service if needed.
Lists essential tools like an adjustable wrench and safety goggles needed for installation.
Details all included parts with descriptions and quantities, essential for verifying completeness before installation.
Step-by-step guide for mounting the faucet assembly into a sink with a single mounting hole.
Instructions for installing the faucet assembly into a sink with three mounting holes, noting differences from single-hole.
Details on attaching the fast mounting nut and connecting the pull-down hose to the quick connector securely.
Guide on connecting hot and cold supply hoses to the correct water valves and securing them.
Guidance on attaching the counterweight and correctly installing four AA batteries into the battery box.
Steps to connect the battery box cable with the sensor cable and securely hang the battery box.
Procedure to flush water lines and check for leaks after installation is completed.
Instructions for attaching and tightening the spray head onto the spray hose.
Steps for disconnecting the pull-down hose from the quick connector by squeezing the tabs.
Guide on operating the faucet via sensor and handle, including auto shut-off and recommendations.
Use neutral detergent and soft cloth for cleaning; avoid abrasive cleaners and corrosive substances.
Explains sensor light flashing for low battery and constant on for immediate replacement.
Addresses handle, water supply, sensor range, and flow rate problems.
Covers water shut-off, pressure, hose retraction, and sensor light issues.
Lists all available service parts with their respective part numbers for replacement or repair.
