Glendinning EEC4 User Manual

EEC4 Installation Manual
14
Move the STBD engine handle by itself — both
STBD and PORT engines will respond simulta-
neously.
Bump Mode — While the boat is underway and
is in a safe area that will allow maneuvering, and
while the control handles are both in gear and
above the engine idle speed, demonstrate the
“bump up” (speed increment) by pressing and
releasing the ACTIVE button. Repeat several
times.
Demonstrate the “bump down” (speed decre-
ment) by pressing and releasing the ACTIVE
and WARM / SYNC buttons together. Repeat
several times.
Control Head Dimmer — To demonstrate the
dim light capability of the control head lights,
press and hold the ACTIVE and WARM / SYNC
buttons simultaneously for about 4 seconds.
Restore the control head lights to normal bright-
ness by pressing and holding the ACTIVE and
WARM / SYNC buttons simultaneously once
again, for about 4 seconds.
Station Transfer (multi-station applications)
— While the boat is underway and is in a safe
area that will allow maneuvering, follow the sta-
tion transfer described in section 2.5 and trans-
fer control from one control station to another.
Try transferring control from one station to
another while at cruising speed, in order to
obtain a minimum speed change.
Each time that the control head buttons are
pressed — either speed increment or decrement
— the engine RPM will increase or decrease
approximately 10 RPM.
The different control head light settings and the
method of changing that setting.

Glendinning EEC4 Specifications

General

Brand	Glendinning
Model	EEC4
Category	Control Unit
Language	English