14
6.2. Electrical connection
Check the operating voltage and frequency of the hydraulic power lift’s
electro-hydraulic control unit. This information is provided on the label
located on the control unit’s protective guard.
The electrical distribution panel which powers the hydraulic power lift’s
control unit must contain a three fuse valves and a circuit breaker.
The connection between the electrical distribution panel and the control unit
must be performed using the supplied cable.
If the control unit’s electrical power cable is too short, it must be completely
replaced with a longer cable, with technical and safety characteristics
identical to those of the original.
IT IS FORBIDDEN TO SPLICE THE POWER CABLE
DANGER !!!
It is forbidden to connect the hydraulic power lift’s electrical system
directly to the garage’s system outlets: Distribution system
malfunctions could result in irreparable damage to the control unit
and serious operator injury.
Before connecting the control unit’s power cable to the electrical distribution
panel, make sure that the switch is in its “O” (off) position
To Next Page
Loading...
