Globalsat TR-206 - Codeword of Command

29
2.8 Codeword of Command
Commands are used to control the device activity. A command message is
composed of one or several command codeword. Each command codeword can
incorporate configuration parameter setting. Please refer to section 2.4 for
message format. Command message could be sent by SMS or TCP or UDP.
Command’s Codeword
Codeword
Parameters
Description
M7
Set Standby Mode
M2
Set Periodic Mode
M3
Set On-Line mode
M4
Set Motion mode
M8
Set Off mode
N0
Set Timer
N1
Ping device
N2
Trigger vibration
N6
Enable Geo-fence
N7
Disable Geo-fence
N8
Enable Data logger
N9
Disable Data logger
Na
Dismiss SOS alarm
Ne
Dismiss Geo-fence alarm
Nh
Dismiss low battery alarm
Ni
Dismiss All alarm
L1
Read Configuration
Adding up to 1-5 parameters.
If parameter=(ALL), then all user
configuration data will be reported.
L3
Read Geo-fence
L4
Make TR-206 connect to
Server