Globalsat TR-206 - Codeword of Configuration Parameters

12
2.7 Codeword of Configuration Parameters
Most behaviors of TR-206 could be changed by Configuration Parameters. You
could change the setting of configuration parameters by the following methods.
1. Connect TR-206 to personal computer via USB cable and then set the
configuration parameters by “TR206 Config Tool_DEV”.
2. Send the “GSS,….!” setting with the configuration parameters to TR-206
3. Send the “GSC,….!” command with the configuration parameters to TR-206
All the settings or commands could be sent by SMS or TCP or UDP.
You could also send L1 command to read the present setting of TR-206.
Configure Parameters
Code
words
Parameters
Type
Description
Main
Device
O5
Device ID
char(16)
O7
Firmware Version
char(28)
Read only
O6
Time Zone Offset
s32, in
seconds
-43200 ~ 46800
O4
Power on operating
mode
u8
2=Periodic 3=On-
line 4=Motion
7=Standby
Default=7
B2
IMEI code
char(16)
Read only
SIM
B0
PIN code
char(7)
B1
Phone number of
SIM card
char(20)
B3
IMSI number
char(16)
Read only
Vibrator
I2
Enable/ disable
TR-206 to vibrate
after pressing SOS
key
1/0
0=disable
1=enable