Globalsat TR-206 - 14 Simple Command

80
14 Simple Command
Typical command of TR-206 is composed of command code words, parameters &
checksum. The code words are hard to remember and you may need a tool to
generate the checksum. The purpose of simple command is to simplify the
command format and send command without checksum. You could send simple
commands to TR-206 by mobile phone’s SMS.
The format of simple command sentence is:
“password,simple command 1,simple command 2,simple command 3,……”
In order to protect the privacy, the sentence starts with a password field. The
password is defined by configuration parameter ‘OU’. If ‘OU’ is set as blank, then
the password field is omitted. This password is also used as the password of PC
utility.
A complete command sentence has one or multiple simple commands. Do not
insert any space byte between commands. Each simple command is composed of
a command codeword and an optional parameter. If there’s no parameter for the
command, TR-206 will refer to present setting for operation. The available
commands are listed in the following table.
Command
Codeword
Optional Parameter
Ping report
PI
=tolerance time of GPS fix
Set Periodic mode
PR
=periodic report interval
Set On-line mode
OL
=on-line report interval
Set Motion moving report interval
MM
=moving report interval
Set Motion static report interval
MS
=static report interval.
Link to server
LI
Reset device
RS
Standby mode
SP
Please note that the simple command is case sensitive. All simple commands are
in capital. To enable the simple command, please set configuration parameter A5
to 1.