Globalsat TR-206 - Page 47

47
6.3 On-Line Mode
In On-Line mode, TR-206 works in the same way as that of periodic mode except
it will keep GPRS connection after sending report. If TR-206 detects the GPRS
connection is cut, it will try to connect to server for one time. If it cannot connect
to server, it will re-connect to server at next report time.
Please refer to section “4.3 GPRS connection” for GPRS on-line operation.
The parameters of On-Line mode are listed below.
Code
word
Parameters
Value
Description
Q0
Report interval
1~4 Giga seconds
Q2
Report Media
Media type
Please refer to 2.9
Report media
Q3
Traveled distance for
sending out report
0=disable
1~4Giga
Unit: meter
If you want TR-206 to
send reports according
to traveled distance,
you have to extra make
GPS on. Please refer to
“Chapter 4 GPS.”
Commands format:
GSC,IMEI,M3*Checksum!
Command Codeword
Parameters
M3
On-line mode
Example 1:
Ask TR-206 set on-line report with interval of 60 seconds and report by UDP
GSC,011412000010789,M3(Q0=60,Q2=04)*34!