2.5 Format of Report Message
Report message is generated by the TR-206 to inform the application server
of its location and status. There are three types of GPRS report message
format, “format 0”, “format 1” and “format 2”.
Report format 0 (GSr,…) & format 1 (GSh,…) are configurable reports. They
are composed of report prefix and report parameters which are described
in section 2.6.
Report format 2 contains cell ID and status information. It is used as a
replacement of format 0 when GPS fix is not available. The format of report
format 2 is not configurable.
Please refer to “Chapter 12. Report” for detailed definitions.
For example:
TR-206 -> Server (format 0)
If configuration parameter O3= SORPZAB27GHKLMN*U!, then the report is
GSr,IMEI,Device_Mode,Report_Type,Alarm_Status,Geofence_status,GPS_F
ix,UTC_Date,UTC_Time,Longitude,Latitude,Altitude,Speed,Heading,Numbe
r_of_Satellites,HDOP,Battery_capacity*checksum!
TR-206 -> Server (format 1)
If configuration parameter ON= SPAN*U!, then the report is
GSh,IMEI,Alarm_Status,GPS_Fix,Battery_capacity*checksum!
TR-206 -> Server (format 2)
GSd,IMEI,Device_Mode,Report_Type,Alarm_Status,Date,Time,Battery_capacity.
“MCC1,MNC1,LAC1,CID1,BSIC1,RSSI1”,
“MCC2,MNC2,LAC2,CID2,BSIC2,RSSI2”,
“MCC3,MNC3,LAC3,CID3,BSIC3,RSSI3”,…*checksum!
To Next Page
Loading...
