Page 11
Troubleshooting
PROBLEM SOLUTION
Cannot enter a tare weight through keyboard. Tare weight must end in the smallest division of scale
weight. (Digital Tare Entry must be enabled)
After turning on scale there are no displays and no
beeps.
Make sure scale is plugged into a live outlet.
Unplug scale from outlet and check main fuse.
After turning on scale there are no displays, but buzzer
sounds continuously.
Make sure weigh platter is mounted on scale correctly.
Make sure no objects are touching weigh platter from
above, side or below.
Scale is out of calibration due to overload or shock
load. Contact service representative.
Reading weight is unstable. Make sure no objects are touching weigh platter from
above, side or below.
Make sure scale is level.
Check for air currents, vibration or unstable mounting
surface.
To Next Page
Loading...
