Page 22
Cleaning
• Disconnect the power supply before cleaning.
• Keep the machine and Operator Keysheet free of dust and dirt.
• Make sure that all spills are wiped clean, especially on the weigh platter.
• Do not put components in dishwasher.
• Dilute detergent per supplier’s instruction.
• Do not hose down or pressure wash any part of the scale.
• Never use a scrubber pad, steel wool, or abrasive material to clean the scale.
• Clean the scale with a mild detergent and warm water solution.
• Do not allow moisture to get into the load cell mounted under the scale weigh platter. Water damage is not
covered under the limited warranty.
• When cleaning the scale, only use a soft, damp cloth with a mild cleaner. Never use volatile or caustic liquids.
Cleaning the Print Head
1. Dip a cotton swab into the thermal print head cleaning solution
provided with the scale. Isopropyl rubbing alcohol can also be
used.
2. Rub the cotton swab on the print head until debris is removed.
3. Allow the alcohol to air dry.
DO NOT use cloth or other material to dry the
print head. This can possibly damage the print head.
If labels have become stuck to print head, NEVER use any sharp or metal object to scrape
labels from print head. Doing so will damage the print head.
Maintenance
It is recommended that the following steps be performed on a daily basis:
1. Make sure that there is a sufcient amount of labels remaining in the machine.
2. Clean the thermal head with a cotton swab, thermal head cleaning solution or isopropyl rubbing alcohol only.
Cleaning/Maintenance
Thermal Print Head
To Next Page
Loading...
Need help?
General
