Page 6
Make sure the scale is placed on a stable, at surface.
Avoid the following areas when installing the machine:
• Areas subject to high temperatures or high humidity
• Areas exposed to direct sunlight
• Areas where water or other liquids can be easily spilled on the machine
• Areas subject to excessive vibration or unstable surfaces
• Areas exposed to direct cold air
• Areas subject to low temperatures
• Areas subject to a lot of dirt
• Areas with large voltage uctuations
Check the level indicator to make sure the scale is level. If the machine is not level, weighing may not be
accurate.
To adjust the machine to a level position, rotate the four adjustment feet until the level bubble is completely
centered in the round level indicator.
Plug the power cord into the AC power outlet on the bottom side of the scale.
Installation
Key Scale Components
Scale Set-Up Keysheet
AC Power Cord
Connection
(On bottom of scale)
On/Off
Power
Switch
Vendor Display
Weigh Platter
Label Printer
Customer Display
Level Indicator
Cash
Drawer
USB
LAN
(Ethernet Cable required
to connect with PC)
Operating Keysheet
Adjustable Feet
Keysheet
AC Power Cord
Tie-downs
To Next Page
Loading...
Need help?
General
