Glow-worm Climapro2RF - Page 13

0020094585_01-08/10-Glow-worm
- 11 -
HOWTOUSEYOURCLIMAPRO
2
RF
Tosetanoperatingtimeslot:
Programmingforadaybeginsat00:00witha
maximumof7timeintervalsover24hours.
• Increaseorreducewiththe

buttonstodisplaythedesiredambient
temperaturesettingandvalidatewith
button
.
• Denetheendofthetimeintervalwith
the
buttonsandvalidatewiththe
button.
• Begintheprogrammingoperations
againifyouwishtoaddothertime
intervals.
Tomodifyasetting:
• Usethebuttons
(goback)or
(goforward)tohighlightthe
settinginquestion.
• Modifyatemperatureoratimewith
the
buttonsandvalidatewiththe
button.
Todeleteatimeinterval:
Deletionisperformed:
- timeintervalbytimeinterval,
- fromthelasttimeintervaltotherst.
• Usethebutton
tohighlightthe
lasttimeintervalthatwasset.
• Usethebutton todisplay .
Thedisplayautomaticallygoesto

anddeletestheprogrammedtemperature.
Thesettingfortheprevioustimeinterval
thenappliesupto .
• Validatewiththebutton
or
deleteanothertimeinterval.
Todeleteanothertimeinterval:
• Usethebutton
tohighlightthe
previoustimeintervalandperformthe
actionagain.
Copy a day
Thisallowsyoutocopyaprogramfrom
onedaytootherdays.
Thisallowstheselecteddaytobecopied:
- toadayoftheweek
- toweekdays(MondaytoFriday)
- toafullweek(Monday-Sunday).
Onceadayhasbeenprogrammed,you
areautomaticallyreturnedtotheselection
screenofthedaytobeprogrammed.
• Selectthefunction(copyaday)and
pressthebutton toconrm.