What to do if fault code reappears on Glow-worm ENERGY 25r?
If a fault code reappears on your Glow-worm Boiler even after multiple reset attempts, the suggested solution is to contact customer service for assistance.
How to troubleshoot fault codes (F.XX) on Glow-worm ENERGY 25r?
To address fault codes (F.XX) on your Glow-worm Boiler, refer to the table in the appendix for advice or use the check programme(s).
How to delete the fault memory on Glow-worm ENERGY 25r?
To delete the fault memory on your Glow-worm Boiler, use function d.94.
General| Mounting | Wall-mounted |
|---|---|
| Output Rating | 25 kW |
| Fuel Type | Natural Gas |
| Hot Water Flow Rate | 10.2 l/min |
| Efficiency Rating | A |
| ErP Heating | A |
| ErP Water | A |
| Central Heating Flow Temperature Range | 30 - 80 °C |
| Maximum Working Pressure | 3 bar |
| Warranty | 2 years |
| Type | Combi |
Precautions regarding escaping flue gas and condensate trap.
Safety measures for blocked or leaking flue gas routes.
Safety precautions for escaping hot flue gases.
Warnings about using the product near flammable materials.
Safety measures to prevent electric shock during maintenance.
Importance of installing necessary safety devices.
Specifies required clearances around the product for installation.
How to use diagnostic codes to adapt the product to system requirements.
Using check programmes, initial start-up, and gas checks.
Checking and adjusting gas settings, including flow rate and connection pressure.
Verifying flue gas system integrity and checking CO2 content.
Observing intervals, using original seals, and procuring spare parts.
Addressing fault codes, accessing fault memory, and preparing for repair.
Detailed steps for replacing the burner, gas-air unit, heat exchanger, and PCBs.
Table listing required inspection and maintenance tasks and intervals.
Comprehensive lists of diagnostic codes and their meanings.
Schematic diagrams showing electrical connections and component layout.
Specific wiring diagram for the 30 kW model.
Checklist for boiler installation, commissioning, and servicing.
Detailed checklist for commissioning, including controls and system checks.
To Next Page