EasyManua.ls Logo

GM V2H Bundle - IMPORTANT SAFETY INSTRUCTIONS; Save These Instructions; Federal Communications Commission Interference Statement

Default Icon
22 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
GM Energy V2H Bundle User Manual
IMPORTANT SAFETY INSTRUCTIONS
Save These Instructions
To prevent the risk of PROPERTY DAMAGE, SERIOUS INJURY or DEATH, read and follow all warnings, safety precautions and instructions in this User Manual,
each component Installation and Operation Manual, and your GM EV Owner’s Manual. Keep this User Manual for future reference.
The GM EV charging solution should be installed only by a licensed contractor and/or a licensed electrician in accordance with all applicable state, local and
national electrical codes and standards.
In the event of a re in or around the components, evacuate the premises and contact local emergency services.
Federal Communications Commission
Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of
the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected
Consult the dealer or an experienced radio/TV technician for help
FCC Caution: Any changes or modications not expressly approved by the
party responsible for compliance could void the user’s authority to operate
this equipment.
This transmitter must not be co-located or operated in conjunction with any
other antenna or transmitter.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance of 20 cm between the radiator and your body.
WARNING
The GM Energy Home equipment should not be used as a
primary or backup power source for medical equipment or any
other products in which failure could lead to injury or loss of life.
Please read the instructions carefully and follow all safety precautions in each Installation and Operation manual before using
these products. Access these manuals on the GM Energy website https://gmenergy.gm.com/for-home/installation-support
WARNING
Do not paint the components.
Changing the color of the
external-facing surfaces can
degrade the product life.
CAUTION
WARNING
To reduce risk of re, electric shock or serious injury:
Do not attempt to open any equipment unless otherwise directed by
this user manual.
Do not attempt to use any part of the system or x/alter the
components if the system appears physically damaged. Contact the
GM Energy Customer Support Center
Do not store any ammable liquids or gases near the system or
its components
Do not expose any of the equipment to direct ames
Do not submerge the equipment in water
Do not use high-pressure water to clean the equipment
Do not clean the equipment with harsh cleaning chemicals
Do not remove any labels from the system or installed components
Do not place foreign objects on top of any of the installed components
Do not lean any foreign objects on any of the installed components
Ensure proper clearances are maintained in the area surrounding the
installed components
Ensure components are installed and maintained in areas with
proper ventilation
Do not attempt to alter the wiring of the components. Incorrect wiring
can lead to high-voltage exposure
WARNING
To reduce the risk of strangulation, keep small
children away from the cord of the Charging
Coupler and ALWAYS stow the Charging Coupler
after use.

Other manuals for GM V2H Bundle

Related product manuals