2626 2727
12. App - connection setup
The go-e Charger can also be used without an app.
Download the go-e Charger app if you want to change
basic settings, use comfort functions, read the inter-
nal electricity meter or control the charger remotely.
The go-e Charger app is available for download on
the platforms listed opposite, depending on the ope-
rating system of your mobile device.
Set up connection via hotspot
1. Some smartphones require deactivating mobile
data and terminating active WiFi connections.
2. Either scan the QR code of the reset card (an ex-
ternal app may be required for this) or manually
search for the charger‘s network (displayed as
go-e-xxxxxx) in the settings of your mobile device
to connect to the charger‘s hotspot. If you con-
nect manually, you need to enter the password
that you will nd on the reset card under „Hot-
spot key“.
3. Now launch the go-e Charger app.
4. If the „Charging“ page is already displayed, you
can already operate the charger locally via the
app. Otherwise, you need to select your go-e
Charger in the app beforehand.
12. App - connection setup
Set up connection via WiFi
For remote control of the charger and for some com-
fort functions, a WiFi connection of the charger is es-
sential.
1. To connect to the WiFi network, you have to esta-
blish an active hotspot connection to the Charger
(as described above).
2. Then tap the „+“ icon in the app.
3. On the following screen, select „Initial setup for
new go-e Charger“. As soon as the hotspot con-
nection has been detected, tap on „Next“. On the
next screen, the connection to WiFi needs to be
activated.
4. Enter the name of your WiFi („SSID“) or select
your WiFi (if displayed). You also need to enter
the „password“ of this WiFi network. As soon as
the connection has been established, a „Next“
button appears, which you have to tap. Follow
the subsequent instructions of the app until the
„Done“ button appears. Tap this button.
5. Check whether the connection to the go-e Cloud
is allowed under „Advanced settings“ (in the „In-
ternet“ tab of the go-e Charger app).
6. Disconnect the hotspot connection to the Char-
ger, establish a smartphone internet connection
to control the Charger remotely via mobile data
or WiFi.
3.3.
3.
Installation and operating manual go-e Charger Gemini ex V 1.4Installation and operating manual go-e Charger Gemini ex V 1.4
To Next Page
Loading...
