go-e Gemini flex - Page 13

2424 2525
10. LED status display/troubleshooting
Connection cable/fuse
The LEDs do not light up despite a power connection.
Check the overload protection of the connection.
Start of the charger does not end
The LEDs light up permanently in rainbow colours.
If the charger does not leave this mode, the WiFi
signal may be disturbed. Please remove possible
sources of interference (e.g. devices with a WiFi mesh
network).
Firmware update failed
The LEDs light up alternately red and pink.
The rmware update could not be completed suc-
cessfully. Please try again.
11. Reset card/RFID chip
Reset to factory settings
You can also use the reset card to reset the go-e
Charger to factory settings:
• Hold the reset card in front of the chargers RFID
reader
• All LEDs light up red briey to conrm
The stored RFID chips and assigned consumption
data are not deleted during this process
.
go-e Charger reset card
On the back of the reset card you will find important
access data which you need to set up the app control
of the charger:
• “Serial number“: Serial number of the go-e Charger
• “Hotspot SSID“: WiFi hotspot name of the charger
• “Hotspot key“: WiFi hotspot password of the device
• “QR-Code“: Automatically connection to the hotspot
Ideally, leave the reset card at a secure location where
you can quickly access it in case you need it.
If you install the go-e Charger outdoors, you can
protect the device against use by unauthorised
persons by means of an RFID chip. In the settings of
the go-e Charger app, „Authentication required“ or
„RFID/App required“ needs to be selected for this.
The delivered RFID chip is already learned.
To authenticate a person authorised for charging,
the chip needs to be held in front of the RFID reader
(below the logo of the charger)before each charging
process. Alternatively, authentication can be done by
tapping the round button of the tab „Charging“ of the
go-e Charger app.
11. Reset card/RFID chip
Consumption overview for several users
Furthermore, additional user accounts can be created
with additional RFID chips (available as accessories).
This is useful if several people share the unit and the
charged current should be displayed separately for
each user in the app.
Additional RFID chips can be learned via the app
(„Settings“/“RFID chips“). Simply select one of the free
slots and follow the instructions in the app. The chips
can be renamed individually in the app.
Any RFID chip/card that transmits on a frequency
of 13.56 MHz (e.g. also many credit cards) can be
learned.
Protection against unauthorised charging
RFID chip
Installation and operating manual go-e Charger Gemini ex V 1.4Installation and operating manual go-e Charger Gemini ex V 1.4