[page 16] | gpelectric.com
INSTALLATION
4.2 INVERTER SHUTDOWN
The Inverter has a number of shutdown points, for the safety of the operator, the Inverter,
and the devices being used with it.
•
If the DC input voltage drops too low, the alarm on the Inverter will sound. If the
input voltage drops further, the Inverter will shut down automatically to prevent
permanent battery damage. Recharge the battery as soon as possible.
•
If the DC input voltage exceeds 16 VDC, the Inverter will shut down automatically.
• If the output load power rises higher than the rating power of the Inverter, the
Inverter may shut down automatically.
•
The Inverter may automatically shut down if its internal temperature gets too high.
Note: even though this Inverter has built-in mechanisms to minimize damage, these situations
should be avoided because they can still damage the Inverter or battery.
4.3 WHERE TO INSTALL
Your Inverter should be installed in a location that meets the following requirements:
1. Dry: do not allow water to drip or splash on the Inverter.
2. Cool: ambient air temperature should be between 0°C and 40°C (the cooler the better).
3. Ventilated: allow at least two inches of clearance around the inverter for airow. Ensure
the ventilation openings on the rear and bottom of the unit are not obstructed.
4.
Safe: do not install the Inverter in the same compartment as batteries or in any compartment
capable of igniting ammable liquids such as gasoline.
5. The Inverter should be located within 10 feet of the batteries.
To Next Page
Loading...
Need help?
General
