Go Power GP-PWM-30-UL User Manual

GP-PWM-30-UL
_________________________________________________________________________________
16
© 2018 GoPower!
Next, select the charging
profile of Battery 1 by
pressing the B Button to
toggle through the profile
options: Sealed/Gel, AGM
or Flooded.
To confirm the battery
profile, press and hold the
A Button for 3 seconds.
Setting Battery 2
If you have a second
battery connected, the
controller will immediately
prompt you to set the
battery type for Battery 2
with a blinking number 2.
If there is not a second battery connected to the
controller, or if the second battery is connected with
reverse polarity, the controller will not prompt you to select battery type
for Battery 2, and no status information will be displayed on the LCD
screen.
To select the charging
profile of Battery 2, press
the B Button to toggle
through the profile
options: Sealed/Gel,
AGM or Flooded.
To confirm the battery
profile, press and hold
the A Button for 3
seconds.
Non-volatile memory: Any settings made on the GP-PWM-30-UL will be
saved even when the power has been disconnected from the controller.
Refer to the Battery Charge Profile Chart below for details on each
profile.
GP-PWM-30-UL Solar Controller
GP-PWM-30-UL Solar Controller
GP-PWM-30-UL Solar Controller
GP-PWM-30-UL SOLAR CONTROLLER
GP-PWM-30-UL SOLAR CONTROLLER
GP-PWM-30-UL SOLAR CONTROLLER

Go Power GP-PWM-30-UL Specifications

General

Brand	Go Power
Model	GP-PWM-30-UL
Category	Controller
Language	English