Go Power GP-PWM-30-UL User Manual

GP-PWM-30-UL
_________________________________________________________________________________
19
© 2018 GoPower!
Push the B Button to show
the PV charging current for
battery 1. The GP-PWM-
30-UL will begin to limit the
current as Battery 1
reaches a full charge. The
current that is not used for
Battery 1, is used to charge
Battery 2.
Icons Displayed: Arrow,
Ampere Symbol (A),
Battery SOC, Symbol 1
The battery state of charge
is shown as a percentage.
Icons Displayed: Battery
SOC, Percent Symbol (%),
Symbol 1
A value of 100% will only
be displayed after a Boost
or Equalize charge
completes.
Battery 2 Status Values
Push the B Button to show
the battery 2 voltage.
Icons Displayed: Battery
SOC, Volt Symbol (V),
Symbol 2
This will only be displayed
if there are two battery
banks connected and
battery bank 2 is connected
with correct polarity.
Push the B Button to show
the PV charging current for
battery 2. The GP-PWM-
30-UL will begin to limit the
current as the battery 2
reaches a full charge.
GP-PWM-30-UL Solar Controller
GP-PWM-30-UL Solar Controller
GP-PWM-30-UL Solar Controller
GP-PWM-30-UL Solar Controller

Go Power GP-PWM-30-UL Specifications

General

Brand	Go Power
Model	GP-PWM-30-UL
Category	Controller
Language	English