Go Power GP-PWM-30-UL User Manual

GP-PWM-30-UL
_________________________________________________________________________________
21
© 2018 GoPower!
The controller does not display over voltage on
battery 2.
Low Voltage
Low battery 1: If the SOC
of battery bank 1 reaches
0%, the battery SOC
symbol will show the text
“LOW” beneath it. The
controller will continue
operating in this condition
and will only stop operating
if the voltage of Battery 1
drops below 9.0 VDC.
Low battery 2: If there are
two battery banks
connected and the SOC of
battery bank 2 reaches 0%,
the battery SOC symbol
will show the text “LOW”
beneath it. The controller
will continue operating in
this condition and will only
stop operating if the
voltage of Battery 1 drops
below 9.0 VDC (this is
because the GP-PWM-30-UL is powered by Battery 1).
Icons Displayed: Battery SOC Symbol, LOW, Symbol 1 or 2
Battery 1 Reverse Polarity
If the GP-PWM-30-UL senses reverse polarity on battery 1, the controller
will stop operating, beep continuously and display POL. The controller
will resume operating when the error is cleared.
Icons Displayed: POL
GP-PWM-30-UL Solar Controller
GP-PWM-30-UL Solar Controller

Go Power GP-PWM-30-UL Specifications

General

Brand	Go Power
Model	GP-PWM-30-UL
Category	Controller
Language	English