Godex RT730i - Page 36

3 Printer Setting and Control
032
Label Calibration Button
A hardware button to make a Label Calibration while printer encountering ‘’Media Error’’ during the cases when first-time
printer start up or change label or ribbon to another type, such as change using gap label to continuous or black mark
labels.
RT700i
Press
CALIBRATION BUTTON
Press C-button for 2 seconds, it will make an auto-sensing to calibrate the label and ribbon’s parameters.
Press
****Press C-button is equivalent to the auto-sensing command ‘’~S,SENSOR’’ that will cancel on-printing-job and make the
Label Calibration immediately.