Godox TT685C - Multi Manual Wireless Flash Shooting

A/B/C（RATIO A：B：C）。
3、Setting flash output.
● Press Function Button 3 < >. Turn the Select Dial to set the flash output of the
groups. Press <SET> button to confirm.
4、Taking the picture.
● Each group fires at the set flash ratio.
Setting <M> Flash Mode
You can directly operate the slave unit to manually set the manual flash or stroboscopic flash.
1、Setting the slave unit.
2、Setting flash mode to <M>.
● Press <> button so that < M > is displayed.
● Set the manual flash output.
6、Multi: Manual Wireless Flash Shooting
1、Setting <MULTI> stroboscopic flash.
● Press <MODE> button so that <MULTI> is displayed.
● Setting the stroboscopic flash.

● WhenALL< RATIO OFF>isset,setA,BorCasthefiringgroupfortheslaveunits.
● To fire multiple slave units with the same flash output, select ALL < RATIO OFF > in step 2.

The firing frequency of stroboscopic flash during the optic transmission wireless shooting can be
set from 1Hz to 199Hz (settings from 250 Hz to 500 Hz are not available).