Godox X1 - Transmitter Group Sync and Test Flash

Setting the Transmitter
Automatically Enter Power Saving Mode
1. The flash trigger will go into standby mode after the transmitter enter sleep mode, and the
displays on the LCD panel will disappear.
2. Press any of the button (<TEST> fully pressed/<CH/OK>/<GR>/<MODE>) can wake up the
flash trigger. If the transmitter is attached to the Nikon DSLR camera, half press the shutter
can also wake up the system.
3. If the transmitter is set to single contact mode( isdisplayed), the system will not enter
power saving mode.
Setting the Transmitter
The following table lists the available and unavailable custom functions of this flash. The icon “√”
indicates the flash custom function is supported but “0”indicates the custom function is not
supported. Note: Some icons will be displayed when setting the relevant custom functions to make
users have a good understanding.
ON(The single contact mode set icon
is displayed.)
It is advisable to set the transmitter to single
contact mode when using it to trigger the flash
by PC cord or through camera’s single contact.
Settings and Description
No delay
Master flash synchronization delay N*100 us
(synchronization delay icon is displayed.)
OFF
Setting Signs
0
1~100
--
on
Functions
Synchronization
delay setting
Single contact
mode
Custom
Functions No.
C.Fn-00
C.Fn-01
Application
√
√
C.Fn: Setting Custom Functions
√
Settings and Description
Changing with camera's zoom value, Flash's
auto ZOOM functions should be turned on.
Zoom(20/24/28/35/50/70/80/105/135/
200mm)
PC sync socket connects with camera as an input
PC sync socket connects with flash as an output
Multi Flash OFF
Multi Flash ON
1/128
1/256
OFF
ON
3 groups are displayed
5 groups are displayed
Turn off the beeper on the receive end
Turn on the beeper on the receive end
Setting Signs
AU
20,24,28,35,50,70,
80,105,135,200
In
ou
--
on
1/128
1/256
--
on
03
05
--
on
Functions
Zoom setting
PC sync socket
as an
input/output
Multi Flash
ON/OFF
Minimum power
output value in
M/Multi mode
AF assist
Displayed
groups
Beeper
ON/OFF
Custom
Functions No.
C.Fn-02
C.Fn-03
C.Fn-04
C.Fn-05
C.Fn-06
C.Fn-07
C.Fn-08
Application
√
√
√
√
√
√
Modeling Lamp Control
Double-click the <CH/OK> Button to power ON/OFF the modeling lamp.
- 37 - - 38 -