Godox X1 - Setting the Receiver: Channel and Group

Selecting the Operation Method
Operation
Short press
Double-click
Long press for
2 seconds
Long press for
5 seconds
Short press
Double-click
Long press for
2 seconds
Short press
Button
CH/OK
GR
MODE
X1N Operation Method 2
TTL/M Mode
Status
Normal
Set the channel
Set the group
Function
(under normal status) Enter CH settings; (under settings) Confirm and back
to normal status
Control the ON/OFF of modeling flash
Enter C.Fn custom settings
Switch the Operation Methods (Method 1/Method 2)
Select the group downwardly
Select the group upwardly
Select all the group
Switch the group’s flash mode(TTL/M/OFF)
Function
No (3 groups) / Turning (5 groups) [Note 2]
Set the channel amount
Adjust the group’s POWER/FEC amount
Select
Dial
Selecting the Operation Method
Multi Mode (C.Fn-04-on)
Operation
Short press
Double-click
Long press for
2 seconds
Long press for
5 seconds
Short press
Short press
Long press for
2 seconds
Function
(under normal status) Enter CH settings; (under settings) Confirm and back
to normal status
Control the ON/OFF of modeling flash
Enter C.Fn custom settings
Switch the Operation Methods (Method 1/Method 2)
(under PTH status) Set power / times / frequency hz
(under normal status) Switch the ON/OFF of the < Group>
(under PTH status) Back to normal status
Enter PTH status (P-power,T-times, and H-hz)
Button
CH/OK
GR
MODE
Status
Normal
Set the channel
Set the Group
Set the flash
times
Set the flash
frequency
Function
No (3 groups) /Turning (5 groups) [Note 2]
Adjust the channel amount
Adjust the group’s power amount
Adjust the times amount
Adjust the frequency amount
Select
Dial
- 43 -
- 44 -