Godox Xpro C - As a Wireless Shutter Release Trigger

10
Note: As the studio flash’s minimum output value is 1/32, the output value of the flash
trigger should be set to or over 1/32. As the studio flash do not have TTL and
stroboscopic functions, the flash trigger should be set to M mode in triggering.
As a Wireless Shutter Release Trigger
Operation method:
• Turn off the camera. Take a camera remote cable and insert one end into the
camera’s shutter socket and the other end to the shutter release port of X1R-C to
connect. Power on the camera and the receiver.
• Long press the <Zm/CH> button to set channel, group, mode, and parameters
(refers to the contents of “Setting the Flash Trigger”).
• Press the receiver’s <CH> button to set the same channel to the flash trigger and
press the <Gr> button to set the same group to the flash trigger.
• Half press the < > button to focus and full press the <TEST> button to shoot.
Release the button until the status lamp turns to red.