Godox Xpro C - As a Wireless Original Flash Trigger; As a Wireless Studio Flash Trigger

9
As a Wireless Original Flash Trigger
Take 600EX-RT as an example:
• Turn off the camera and mount the transmitter on camera hotshoe. Then, power
on the flash trigger and the camera.
• Long press the <Zm/CH> button to set channel, group, mode, and parameters
(refers to the contents of “Setting the Flash Trigger”).
• Attach the original flash to the X1R-C receiver. Press the <CH> button on the
receiver to set the same channel to the flash the trigger and press the <Gr>
button to set the same group to the flash trigger (Note: please refer to the
relevant instruction manual when setting the original camera flashes).
• Press the camera shutter to trigger. And the status lamp of the camera flash and
the flash trigger both turn red synchronously.
As a Wireless Studio Flash Trigger
Take GS400II as an example:
• Turn off the camera and mount the transmitter on camera hotshoe. Then, power
on the flash trigger and the camera.
• Long press the <Zm/Ch> button to set channel, group, mode and parameters
(refers to the contents of “Setting the Flash Trigger”).
• Connect the studio flash to power source and power it on. Synchronously press
down the GR/CH> button and <S1/S2> button and the < > wireless icon will be
displayed on the LCD panel. Long press the <GR/CH> button to set the same
channel to the flash trigger, and short press the <GR/CH> button to set the same
group to the flash trigger. (Note: please refer to the relevant instruction manual
when setting the studio flashes of other models).
• Press the camera shutter to trigger. And the status lamp of the camera flash and
the flash trigger both turn red synchronously.