Godox Xpro C - As a Wireless Outdoor Flash Trigger

8
• Long press the <Zm/CH> button to set channel, group, mode and parameter
(refers to the contents of “Setting the Flash Trigger”).
• Turn on the camera flash, press the < > wireless setting button and the < >
wireless icon and <SLAVE> slave unit icon will be displayed on the LCD panel.
Press the <CH> button to set the same channel to the flash trigger and press the
<Gr> button to set the same group to the flash trigger. (Note: please refer to the
relevant instruction manual when setting the camera flashes of other models).
• Press the camera shutter to trigger and the status lamp of the flash trigger turns
red synchronously.
As a Wireless Outdoor Flash Trigger
Take AD600B as an example.
• Turn off the camera and mount the transmitter on camera hotshoe. Then, power
on the flash trigger and the camera.
• Long press the <Zm/CH> button to set channel, group, mode, and parameters
(refers to the contents of “Setting the Flash Trigger”).
• Power on the outdoor flash and press the < > wireless setting button and the
< > wireless icon will be displayed on the LCD panel. Long press the <GR/CH>
button to set the same channel to the flash trigger, and short press the <GR/CH>
button to set the same group to the flash trigger (Note: please refer to the
relevant instruction manual when setting the outdoor flashes of other models).
• Press the camera shutter to trigger and the status lamp of the flash trigger turns
red synchronously.