EasyManua.ls Logo

Golden compass - User Manual

Golden compass
13 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
SERVICE MANUAL
Question and Answer IconNeed help?

Do you have a question about the Golden compass and is the answer not in the manual?

Summary

WARRANTY

SPECIFICATIONS

PREFACE

SERVICING THE POWER CHAIR

Removing and Installing the H-bar Seat Receivers

Steps to remove and install H-bar seat receivers, adjusting height and pitch.

Removing and Installing a Front Caster Arm Cover and Rear Fender

Procedure to remove and install the front caster arm cover and rear fender assembly.

Changing a Drive Wheel and Motor

Instructions for safely removing and installing the drive wheel and motor.

Removing and Installing the Front Caster Arm

Steps to remove and reinstall the front caster arm assembly.

Removing and Installing a Fender-Fork Assembly

Procedure for removing and installing the fender-fork assembly and caster wheel.

Adjusting the Pitch on the Front Casters

Guide to adjusting the front caster pitch for optimal performance and alignment.

Removing and Installing the Battery Tray Shroud

Steps for careful removal and installation of the battery tray shroud.

Removing and Installing the Control Module

Procedure to remove and install the power chair's control module.

Removing and Installing the Retractable Desk Arm Assembly

Instructions for removing and installing the retractable desk arm assembly.

Moving the Joystick to the Left Side of the Power Chair

Guide to relocating the joystick control to the left armrest assembly.

Installing the Seatbelt

Steps to properly install the seatbelt onto the power chair.

TROUBLESHOOTING ELECTRONICS AND THE SHARK CONTROLLER

Flash Code 1: Possible Stall Timeout or User Fault

Troubleshooting steps for stall timeout or user fault flash codes.

Flash Code 2: Battery Fault

Procedure to diagnose battery faults and check source voltage.

Flash Code 2 Amber: Over- or Under-voltage Fault

Diagnosing over/under-voltage faults and checking battery charger voltage.

Flash Code 3 (Right Motor Fault) or 4 (Left Motor Fault)

How to troubleshoot motor faults and check circuit breaker continuity.

Flash Code 5 (Right Park Break Fault) or 6 (Left Park Break Fault)

Steps to diagnose park brake faults and check connectors.

Flash Code 7: Joystick Fault

Procedure to check jumper harness voltage for joystick-related faults.

Flash Code 8: Control Module Fault

How to test control module voltage for proper operation.

Flash Code 9: Communications Fault

Troubleshooting communications faults and guidance on joystick replacement.

Flash Code 10: Unknown Fault

Steps for handling unknown faults, including wiring checks and agent consultation.

Golden compass Specifications

General IconGeneral
BrandGolden
Modelcompass
CategoryWheelchair
LanguageEnglish

Related product manuals