76
Once the engine has caught: release the key which will automatically reset to
operating position "1".
Check all the indicator and status signalling lights.
The water temperature needle (n. 1 fig.2): once the engine is hot and during
work, should be between 80° and 100°. If the red warning light (n.19 fig.2)
comes on, check the engine cooling circuit.
Stop the engine and check the cooling liquid level (section 6.4). Also check if
the radiator core is clean and, lastly, check fan belt tension.
4.3 STOPPING THE ENGINE
Move the throttle lever (n.11 fig.1) forward and turn the ignition key fig. 4 (n.2
fig.1) to “0”.
Pull up the parking brake n.13 fig.1.
WARNING: The steering action of the power steering system will be
reduced if the engine accidentally stops. Depress the main brake to allow the
machine to come to a full stop.
4.4 DASHBOARD DISPLAY
Use button n.36 fig. 1 to select digital display readout n.17 fig.2:
When the tractor is switched on, the default display setting is for tractor speed. in
km/h.
Press button n.36 fig.1 to scroll through the other display possibilities as follows:
FRONT Front PTO Rpm
CENTR Central PTO Rpm
REAR Rear PTO Rpm
If no PTO has been selected, the display will flash for 5 seconds and then
display 000.
Press button n.36 fig.1 again and the display will return to display the speed in
km/h.
To Next Page
Loading...
Need help?
General