golmar Art 7 H /G2+ - Door Panel Call Screen

12
DOOR PANEL CALL SCREEN
ART 7 /G2+ MONITORH
This screen is displayed when you receive a call or when you press the button below icon of the main menu.
During a call, icon displayed on the screen will blink green (during the call process). In the top centre of the
screen, the date and time are shown and, on the right, the source of the image is displayed (door panel 1 doorto
panel , camera 1 camera ). The call has a duration of 45 seconds4 to 4
.
Press the hidden button below icon to cancel the current call or display and return to the main
menu.
Press the button below icon / to start or end audio communication with the door
panel displayed respectively. Communication has a maximum duration of 90 seconds."
Once communication has ended, the screen will turn off.
Press the hidden button below icon to change the source of the image as long as the system has
more than one door panel or has an external camera connected and display has been activated
(see pp. ). It is possible to make the change during display, call and communication21-24
processes.
A few seconds after receiving a call, it automatically takes a photograph. In the top left of the screen,
icon is displayed and indicator will illuminate. Press the hidden button below icon to
take a picture.
If a Micro SD card is inserted, a 15-second video automatically starts recording a few seconds after
receiving the call. In the top left of the screen, icon is displayed and indicator will illuminate
(see p. to configure video recording mode). Then a short 1-second press on the hidden button9
below icon will take a photograph or a long -second press will record a video.3
Press the button below icon to activate the lock release (or device connected to the CV output of the
door panel) for 3 seconds(factory setting, programmable by the installer; see pp. . During21-24)
activation, indicator will illuminate.
Press the hidden button below icon to activate the lock release (or device connected to the relay
output of the door panel) for 3 seconds (factory setting, programmable by the installer; see pp. .21-24)
During activation, indicator will illuminate.
1
2
1
2
0 -0 -21 7 019 11:17:10
1
1 2