8
INSTALLATION OF THE DOOR PANEL
Setting the door panel communication volume:
STAINLESS STEEL NEXA MODULAR GB2 VIDEO DOOR ENTRY SYSTEM KIT – HOUSES
If the audio volume of the door panel is too low after turning it on, follow these steps:
- Call the apartment.
- The call is received in the apartment. Establish communication by pressing option on the screen of the
master monitor or the logo on the front of any slave monitor in the apartment (unless the 'display image
' 'Golmar
in call' function is enabled on the slave monitor, in which case, option must be pressed).
- Then press the button used to call the apartment for 3 seconds until a number of confirmation tones are heard
and the door panel communication LED starts to blink.
- Each press on the call button will increase the door panel volume and blink speed of the LED.
There are 5 volume settings and the blink speed of LED will increase for each. Slow to fast blink - low to high
volume. After reaching setting 5, maximum blink speed and volume, the next setting is 1, minimum blink speed
and volume (carousel mode).
- To save the volume setting keep the button pressed until a number of confirmation tones are heard and the door
panel communication LED turns off.
Selecting the vocal synthesis language:
To activate the vocal synthesis of the door panel, follow these steps:
- Disconnect the door panel's power supply.
- Set DIP 6 on the sound module (see page 6) to ON.
- Reconnect the door panel's power supply.
- Press and hold down button P2 on the sound module for 6 seconds (until the confirmation
tones end).
- Then continue pressing until the required language is reached.
- Finally, set DIP 6 to OFF.
Aconfirmation tone will be heard.
Adjusting the vocal synthesis volume:
If after starting the system the vocal synthesis volume of the door panel seems inadequate,
follow these steps:
- Disconnect the door panel's power supply.
- Set DIP 6 on the sound module (see page 6) to OFF.
- Reconnect the door panel's power supply.
- Set DIP 6 to ON.
- Press and hold down button P2 on the sound module for 6 seconds (until the vocal synthesis
volume is heard and LED on the door panel starts to blink).
- Then continue pressing to increase the vocal synthesis volume and the blink speed of LED .
There are 5 volume settings and the blink speed of LED will increase for each. Slow to fast blink - low to high
volume. After reaching setting 5, maximum blink speed and volume, the next setting will be 1, minimum blink
speed and synthesis volume (carousel mode). Once the required volume is selected, stop pressing button P2.
- Finally, set DIP 6 to OFF.
Aconfirmation tone will be heard and LED on the door panel will turn off.
To Next Page
Loading...
Need help?
General
