MS400
Translation of the original operating instruction and spare parts list
- 20-
5007045-00
BA-E
®
• Mount back the outer flange.
• Tighten the left threaded hexagonal nut on the motor shaft.
• Close the blade guard. Tighten the screw at the front and on the side.
4.6 Electrical connections
Before connecting the machine to a power supply, make sure:
• The voltage/phase supply corresponds to the information indicated on the motor plate and
machine plate.
• Available power supply must have ground connection in conformity with safety regulations.
• The size of the electric cable of the extended lead is sufficient (H07RNF 3x2.5mm
2
up to 50m for
230V)
To Next Page
Loading...