MS400
Translation of the original operating instruction and spare parts list
- 26-
5007045-00
BA-E
®
• During the cutting process set the cutting depth manual about
the cutter head handle. Push about the table handle the
cutting table to the front and back again.
5.3.3 Cutting method: 45° bevel cuts
The machine enables to make fixed or multiple steps 45° bevel cuts.
To do 45° bevel cuts, please follow this procedure:
• Switch off the machine and make sure the blade is not rotating.
• Put the cutting table at the front of the machine to clear the
space for the pivoting of the cutting head.
• Loosen the big nut at the back of the cutting head.
• Rotate the cutting head until it stops at 45°.
To Next Page
Loading...