MS400
Translation of the original operating instruction and spare parts list
- 22-
5007045-00
BA-E
®
5.3.1 Cutting method: Fixed depth cutting
In fixed depth cutting, the cutting head is locked in a fixed position. To do fixed depth cutting, please
follow this procedure:
• Switch off the machine and make sure the blade is not rotating.
• Loosen the adjusting handle
and adjust the cutting head to
the desired position.
• Adjust the depth stop and tighten the counter nut to fix it well.
Warning: Never touch rotating parts!
Attention: Transport the unit only when the engine is stopped! This applies also to
a short change of location!
Attention: Wear appropriate individual protective equipment!
To Next Page
Loading...