MS400
Translation of the original operating instruction and spare parts list
- 28-
5007045-00
BA-E
®
• Put your left hand on the table pushing handle. Put your right hand on the cutting head handle.
• Your right hand should be ready to push the emergency stop in case of any unexpected problem.
• Push the cutting table slowly and without undue pressure towards the rotating blade.
To put the cutting head back in the normal position, please follow this procedure:
• Switch off the machine and make sure the blade is not
rotating.
• Put the cutting table at the front of the machine to clear the
space for the pivoting of the cutting head.
• Loosen the big nut at the back of the cutting head.
•
Rotate the cutting head until it stops at 0°.
• Tighten well the big nut at the back and use your hand to
maintain the position of the cutting head at 0° (because the
tighten torque could slightly modify the angle possible of the
cutting head!).
To Next Page
Loading...